Use of Multiple LS units with single T2 base

Adam

Well-Known Member
5PLS
If you are using your T2 and your 2 LS's just start it with one LS and on the second make sure the setup for communication is the same as the 1st LS. Then when done download with LS 1 and then transfer the base file to LS 2. In the points screen use the menu button to recover base point, attach gnss file, and recover dpos session.
 

Michael Stazhkov

Developer
JAVAD GNSS
If you are using your T2 and your 2 LS's just start it with one LS and on the second make sure the setup for communication is the same as the 1st LS. Then when done download with LS 1 and then transfer the base file to LS 2. In the points screen use the menu button to recover base point, attach gnss file, and recover dpos session.
Also there is feature which can automatically do all that. It can be found in Base/Rover setup, you should connect to your Base receiver and go to "Remote Base" -> "Sync DPOS tasks" screen and push "Start synchronization". It will compare time ranges of all Base files and Rover files in current project, find intersection and try to create DPOS tasks if not exist (including downloading GNSS file from Base, creation of Base point, attaching files, etc).
 

Adam

Well-Known Member
5PLS
Also there is feature which can automatically do all that. It can be found in Base/Rover setup, you should connect to your Base receiver and go to "Remote Base" -> "Sync DPOS tasks" screen and push "Start synchronization". It will compare time ranges of all Base files and Rover files in current project, find intersection and try to create DPOS tasks if not exist (including downloading GNSS file from Base, creation of Base point, attaching files, etc).
I tried this and it worked but in DPOS it didn't associate the rover points.
BACKGROUND-TASKS-MANAGER_20190820-11.58.54.png
 

Michael Stazhkov

Developer
JAVAD GNSS
The same on Release version.
It seems just after DPOS session synchronization with base receiver on Base/Rover screens it has state as on your picture until you send it to DPOS. After that JField does analysis and updates DPOS session state to what I see now.
 
I have a project tomorrow where we want to run two LS's from my one T2 base. The base will be on a known point that I shot earlier and processed through DPOS.

After starting the base and connecting with the first LS, how will we connect the second LS? Does it have to go through the 'start base' routine on it's own, or how does it recognize that the base is already running on a known point?

When the job is finished, do both LS's have to go through the 'stop base' and 'download' routines separately?

Thanks...
 

Adam

Well-Known Member
5PLS
Make sure the settings match on both LS units. You will not need to start or stop base with the 2nd LS. Just set it up to listen for corrections.
 

Adam

Well-Known Member
5PLS
You will need to make sure the second LS is set to the same frequency for uhf or same ip for TCP corrections. Once you set that info corrections should be there. Then start collecting.
 
Last edited:
Top