The firmware on the T3 is updated to 4.2. You can start the T3 radio from the LS, just not change the settings.
Its an old OAF that I got to test out the 50hz rate on the IMU. It always says that even though I have updated it many times.
Adam said:
it means that, with firmware 4, I can no longer connect the two ls base / rover with the radios, I hope this is not the caseBase/Rover setup doesn't work for an LS base which sounds like what you are doing. Jcors isnt available for LS bases yet.
it means that, with firmware 4, I can no longer connect the two ls base / rover with the radios, I hope this is not the case
Can I instead connect a t3 (base) and Ls (rover) to jcors with BASE / ROVER SETUP?
I believe it is reading more parameters from the base now so if you are connected through Bluetooth it takes longer.Is anybody noticing longer than usual connection times when starting up your base. Not only getting connected to the base, but starting it. It has more than doubled, if not more. LS+ and T1M. I have updated to the latest stable firmware
Not exactly. Just reading GREIS parameters doesn't take much time.I believe it is reading more parameters from the base now so if you are connected through Bluetooth it takes longer.
You need to use Netview & Modem. WiFi configuration is covered on page 34 of its manual. http://download.javad.com/manuals/NetView/NetViewModem_Software_Manual.pdfNow I'm stopped at the connection of the base (t'3) via wifi (not having a screen like Ls I don't know how to connect it to the wifi router and how to enter the wpa2 code)
Can post a screenshot?Ive got the OK on the left side but not the right side? the right side says "error". LS/T2. T2 WIFI is green.