Recent content by Jim Mitchell

P.S. after you build up a system with the Velodyne - Check out this possibility of a sub $5K LIDAR system. (Hardware only, no software, no computer. ) https://store.dji.com/product/livox-mid?vid=48991 https://inertialsense.com/products/dual-gnss-ins-compass/ (they are adding dual frequency...

Best solution I found was GPS-18 terminated with the connector that plugs straight into the Velodyne box. $60 + shipping https://www.ebay.com/p/Garmin-GPS-18x-LVC-010-00321-36-Receiver/140886013?iid=172056966755&chn=ps We are now using the SBG Ellipse2-D for orientation and position and the...

https://www.use-snip.com/kb/knowledge-base/an-rtcm-message-cheat-sheet/ I purchased the Galileo and Bediou options for the 1M. For RTK we transmit the RTCM3 MSM message which contains information for all the constellations.

VELODYNE PUCK - cannot figure out how to change title. Has anyone interfaced a JAVAD GNSS (SIGMA) with the Velodyne Puck? The Puck requires a NMEA RMC message ($GPRMC) at 1 Hz trasmitted at 9600 baud over a serial cable and a 1Hz PPS TTL signal. I dumbed down the RMC message from $GNRMC to...

Shawn Anecdotal information using Triumph 1M's with Galileo and Bediou at 55 degrees North as base stations transmitting RTCM MSM to Topcon Hiper HR (rover) also with full GNSS constellation. Significant improvement in challenging environments! Bedoiu at the time was less benefit due to fact...

Thank you for the assistance. Resetting the router and turning off the firewall got it to work.

Did that. Still cannot connect.

Also having the same problem trying to get usb drivers not connecting to storage.javad.com

No. Just the usual windows 10 stuff. First time I tried installing the download hung up at 49.2 of 49.8 Mb. I have version NetView 4.7 build 3.69. It installed fine.

Tried Failed same error

I am trying to download the latest NetView modem program. For some reason I can browse through the Javad site, download certain things (RealTimelogger.exe) but I cannot connect with storage.javad.com. Does anyone know who I should contact? ERROR SUMMARY Below is a summary of the errors...

Have you tried hooking up the 1M to NetView and verifying that the internal radio is configured the same as the LS. I have found it easier to configure the 1M radio with NetView rather than using my Victor-LS.

I was also able to get the 4GB upgrade at no cost. Had to request a new OAF and upgrade through NetView. Seamless

Darren - When did you purchase your units?

Darren Can I ask what you paid?