Having trouble downloading a job, cannot connect. Downloaded new Net view and drivers. Tries to connect but fails, it is on my devices page but doe not recognize in Net view any ideas?
I got this message on my LS the other day- The Triumph-2 Hardware Revision 3 doesn't support new features! Pleaase contact JAVADGNSS, Inc for upgrade details. Any ideas?
Yes that is my question, when I used automatic choice for antennae the results were 0.01' of the total station field location vs 0.09' when choosing T2 antennae. I had to push the physical button, having hookup problems with IPAD.
I am having a problem with DPOS or entry of data, when I enter the data to DPOS and leave the antenna to auto i get a closer field horizonal observation than choosing Triumph2, but the vertical is not as good. I had good results before using the DPOS parameters for Triumph2. Could it be a bad...
When I converted to feet and entered them in my old 48 and inversed that is where I got the large area, the points are the same, but I think his one point maybe have been run over.
The inverse is N 45 43 45 W -53.3343'. The Opus report is within a couple hundreds, am I converting it incorrectly to feet? I thought I was using the PA coords.