Randy Hepworth
New Member
It happened last week. I had a project setup with a Local Grid on its own Page using WGS84(ITRF2008) as the underlying coord system with imported local points. Started the project by locating several common points in SPC. I have utilized this procedure many, many times. I then Localized to three points, and all was well, I then paired two incorrect point pairs. (the GPS shot was not for the right Local Grid point number). Obviously at that point my localization went wrong. So I attempted to correct the point pairing. Not sure what happened, but at that time the selection for the Pages that were turned on went screwy. I could turn on all of the Pages, except the Local Grid page would not turn on. If I purposely chose the Local Grid page, all of the other Pages turned off!. I deleted all of the Local Grid points, imported them into a new Local Grid page, and attempted to Localize, but the Survey page would not turn on at the same time as the Local Grid page. I did a work-around that day by importing the local grid points into a SPC based page, and then translated/rotated to the GPS shots.
Now, I am attempting to set up another project today for tomorrow. Same issue: I cannot have the Local Grid page turned on at the same time as any of the other Pages! What's wrong?
Now, I am attempting to set up another project today for tomorrow. Same issue: I cannot have the Local Grid page turned on at the same time as any of the other Pages! What's wrong?