Search results

  1. Adam

    DPOS troubles

    Go to Collect, then Project, tap it and tap send project to support. Give Alexey a note so he knows it's you.
  2. Adam

    Where Have You Been with Your LS Lately?

    It set up there without any help.
  3. Adam

    Where Have You Been with Your LS Lately?

    Doubt you gonna find any sleigh shoes in the South.
  4. Adam

    Where Have You Been with Your LS Lately?

    If you notice the LS center is on the inside face of the post. That is where I will be placing the wire. I staked out each point where a metal tpost will be driven between the larger wooden posts. I will cut the wooden posts to height later. For now I had to climb up on the roof of the buggy to...
  5. Adam

    Where Have You Been with Your LS Lately?

    Locating fence posts...
  6. Adam

    J-POD inside bag

    That bag was what brought about the J-Pack. We told Javad when we were in San Jose that we need to carry more than just the J-pod. I remember the bag above, i think it is was a bag Javad brought in. I think it's a quiver for ye arrows.
  7. Adam

    J-POD inside bag

    The J Pack was designed for carrying all of the equipment including the J pod. It is not included with the J Pod and must be purchased separately. It's $290. I love the J Pack.
  8. Adam

    Accuracy Issues

    The screen must be facing North.
  9. Adam

    Renumber points?

    Edit the point by tapping the pencil icon then change the point name.
  10. Adam

    J-Mate

    Run the user calibration
  11. Adam

    Use of Multiple LS units with single T2 base

    You will need to make sure the second LS is set to the same frequency for uhf or same ip for TCP corrections. Once you set that info corrections should be there. Then start collecting.
  12. Adam

    Use of Multiple LS units with single T2 base

    Make sure the settings match on both LS units. You will not need to start or stop base with the 2nd LS. Just set it up to listen for corrections.
  13. Adam

    Accuracy Issues

    I wouldn't be able to sleep at night certifying to 0.002' with any equipment I have.
  14. Adam

    Use of Multiple LS units with single T2 base

    I tried this and it worked but in DPOS it didn't associate the rover points.
  15. Adam

    Waiting time to submit to DPOS

    I'd lean toward post processing the base rover vector with dpos over cors processing for the point in canopy. If I'm relying on ppk only definitely shoot it twice.
  16. Adam

    Waiting time to submit to DPOS

    My pole is out more than that. I'd bet it's at least .5mm
  17. Adam

    Waiting time to submit to DPOS

    From what I remember he said the broadcast deals just as good solutions as the others. I may be remembering wrong and there maybe other reasons.
  18. Adam

    Waiting time to submit to DPOS

    That's a great summary Steve. I recall @Alexey Razumovsky saying the broadcast ephemeris is always used in dpos.
  19. Adam

    Waiting time to submit to DPOS

    I usually run dpos that evening. Sometimes the next morning. The results are pretty similar. If you try it to early it will say waiting on cors or use cors that are available but too far away to give good results. In that case wait and try later. It doesn't matter.
Top