Search results

  1. B

    RTN Status - ERROR TIMEOUT

    We were getting ready for the field today and can't seem to get our LS+ connected to our local CORS sites. This happens with both Wifi and LAN connections. RTN Status will say "SOCKET FAILED" then turns to "ERROR TIMEOUT". I've tried turning the RTN configuration on and off, disabling the...
  2. B

    Triumph 2 & HPT435 BT Pairing

    We recently sent our Triumph-2 in for the Base Guard update. I am trying to set up the base and I cannot get the Triumph-2 to pair with the external radio (HPT435BT). How do I get the bluetooth to pair?
  3. B

    Start, Pause, Accept

    I thought that I recently read a post of a future software update that would allow a user to occupy and start recording a point, pause the recording (while a car comes barreling down the road) and then be able to reoccupy the point and continue recording until required "standards" are met. Has...
  4. B

    Point Stakeout

    We used the LS to stake out some silt fence and rough grade stakes yesterday in the field. After staking and recording a point,is it possible to store the "as-staked" point as a different point number rather than the LS storing an "as-staked" point with the same number as the design point number?
  5. B

    User Defined Buttons

    Is it possible to set the user defined buttons as "quick setup settings", i.e. U1: Boundary settings - 30 epochs, Verify w/reset, etc.; U2: Topo settings - 3-5 epochs, Verify w/o reset, etc.... without having to manually change the setting each time? Maybe an option for a future software release?
  6. B

    Unit freezes or shuts off while recording points

    Has anyone experienced the LS freezing (screen goes blank and the battery lights flash) while recording a point? This has occurred on a few occasions now both with CORS and UHF setups. I've had to reset the unit by holding down the power button for 10 seconds. Once I reset the unit...
  7. B

    LS Turned Off While Recording Points & Coordinate Systems Disappear

    We were in the field yesterday on a 55 acre parcel of land using MDOT (Michigan Dept. of Trans.) CORS and on two separate occasions the LS turned off while recording a point. I was able to restart the unit and continue working. I checked back into a few points that we recorded both earlier in...
Top