Search results

Thanks to Phillip Lancaster for fixing this. Phillip cleared NVRAM on the base, which did not help. He changed back to the Release versions (J-Field 4.0.0.1216 and GNSS 4.2.02220225). It had been on Pre-Release. That fixed the problem. I later changed back to Pre-Release (J-Field 4.0.1.469 and...

Not yet.

I am trouble collecting a trajectory. I have successfully used trajectory a bunch in the past, and I'm not sure what I'm doing differently now. When I press Start T., J-Field shows Fixed for the first shot, then changes to CDF for subsequent shots, and the number of satellites drops...

Jim, I use Google Drive and I've never had problems with it. I think that most of the troubles that others have had the last few years have been with Dropbox. You should try Google Drive before you give up on it entirely. It's very handy.

I haven't used a hotspot for a couple years now, but when I did, I found that it shut itself off when the temperature is below about 32°F or above about 100°F. I attached it with some Velcro stickies to the underside of a base tripod leg, which kept it mostly out of sight and sun. I've never...

You should probably use whatever projection you used when you collected the surveyed points. I wish the underlying coordinate system would default to the Project Coordinate System. It's almost always what I change it to, and I can't imagine a scenario where I would use WGS84(ITRF2008). You will...

Localize should work by adding design points first, then surveyed points. I'm not sure why there are no surveyed points to choose. I assume the new page with its new coordinate system are in the same job that you surveyed the point in. You should be able to add surveyed points to the...

It's that time of year again.

It worked for me this morning from J-Field. I just tried processing a file with app.javad.com and I got the same upload error you describe.

It worked for me this morning.

Here are my notes from last time I had to do it. It's been a while, so some of these instructions may be out of date.

I use this GSM antenna. I have found it gives about 10dB more signal than the orange one that came with the LS+. It costs only $6. It fits tighter to the LS - less likely to hook on something- and seems a little more sturdy. With the UHF antenna also installed, it fits at an angle (not quite...

Bummer. It used to work. This is another reason it would be nice to be able to DPOS multiple base files that have been stitched together.

Does enabling correction services on the fly not work anymore? I started a project using TCP corrections and found I was in a place with spotty cell signal, so I tried to start UHF corrections without stopping the base. The remote base screen just says "Waiting...". I checked all the UHF...

Thanks, Matt.

I did a job yesterday that made two short base files on the same point, and I want a single set of coordinates for the base. I started the base the first time with an autonomous position and worked for a little over 2 hours. A thunderstorm came up and the weather service was predicting 2-inch...

Will J-Starr PPP be available on the Triumph-LS+?

I have not seen RTK-RTPK discrepancies anywhere close to that size. How far away is your base?

No. Not if you're just using horizontal positions and ignoring elevations.

Here you go. Triumph-LS Custom Mods