Search results

Release Notes - 4.3.00, when for ls and ls +? Perhaps with a solution to Nrtk and modem problems.

New problem: the update screen is stuck at 30%, even turning it off by forcing a restart, once this has happened it always returns to the same point.

Good morning, I continue to have problems with my Triumph ls+, the modem with the sim connects to the internet once out of 6. Today I tried to detect a strongpoint with Ntrip connection from a regional Gnss, GPS, Galileo, Glonass and Beidou station (about 29 km away), despite being in the open...

Hello, one question: has the "My Questions" section of the old site been abandoned? I escalated an issue in October and never got a response, whereas in the past they responded to me quickly.

Hello, I haven't connected to jcors (Us) for a while. I tried today, but I couldn't. There could be 2 causes. Either that the ntrip service is not active, that the t3 does not connect correctly to the internet. When I click on the jcors base button, LS stops for a minute, flashing yellow...

Hello I have problems with my triumph ls + with connection to the regional rtn network (gps + glonass) in fact I have lower performance than my old navcom Sf3040 (which only has 66 channels). I asked: 1. has anyone experimented with the firmware (testing) 4.2.2.220908 which I think has added the...

H Hello back to having problems with the GSM, it had already happened to me, but then for a good period I no longer had problems. Now again: the telephone connection goes intermittently: sometimes it works and sometimes it doesn't. I have to keep turning the "cellular Data On / off" on and off...

Hello, I performed a survey with my Ls alternating the rtk connection from regional base (Ntrip) and from T-3 via Jcors. I then exported the points detected in the RW5 format to import them into my topography program, but unlike what happens for similar surveys that I performed with another...

Waiting for jcors, which is not known when it will be available, wanting to connect a T-3 as a base to test an rtk connection via ntrip, to an Ls rover, no I have a static ip address available. According to you I could try the free noip.com service, which transforms the dynamic ip into a fixed...

Hello, it is possible to export a RTK rover survey file from triump Ls with the same survce carlson style formatting (see attachment survce.rw5 obtained via triumph-3 connected with usb to survpc) instead of in the * .rw5 format present in exchange data (see attachment exchange.rw5) which is not...

For rtk surveys, the height to be entered is the one read by the rover pole (if no other adapters are mounted), for RTKLIB static surveys at this read height I should also add that of the phase shift of the phase center which, if I'm not mistaken, is 11 cm, right

Waiting to receive the new tool I would like to remove my doubts: doing an RTK survey with Triumph ls in addition to the coordinates, the pdop, the number of satellites etc. the variance covariance matrix matrices are also memorized for each detected and memorized point, in fact these data are...

hi, i am considering the purchase of a rover ls + to replace my current Navcom 3040 sf. I usually connect, in ntrip, as a rover to the cadastre network of my region (tpos network of Trentino, now only gps and glonass, later hopefully also galileo). The question is: could I use the 3040 as a...

Triumph 2 now with GALILEO E1 (B + C) BeiDou B1, B1C (P + D) upgrade or new receiver?

Hello everyone, I tried ls via the virtualroadshow remote link. In the 2 or 6 motor options, the various constellations and their signals can be set. 1. I have seen that L5 excludes l2c and vice versa, why can't we have both? 2. The maximum number of signals, when selecting the monitor says 10...

I was observing, in the virtual roadshow, the satellite state, to understand the functioning of the multiple and advantageous controls of the instrument and I noticed that in the satellite navigations status codes column, the codes 55 or 58 are almost always reported, which refer to the use in...

Good morning, I'm an Italian surveyor, sorry for my approximate English. I currently own a Navcom sf3040 system, I am considering moving to a system that also includes Galileo and Beidou (as soon as the regional land registry network will implement these corrections in the NTRIP service)...