Search results

The update issue has been resolved; please give it a try.

If the RAMS is not convenient for you, then please share screenshots: 1. Base/Rover main screen. 2. UHF Configuration screen. 3. Base Radio status screen (tap on rectangle under Connect/Disconnect button in the Base/Rover screen). 4. Press Home button, tap on the UHF icon and share Rover status...

Hello Jim, If you arrange RAMS connection, as described Andrew Zimin above, we will connect and investigate the issue.

Hello Jason, In order to investigate the issue we would like to ask for remote session. Please follow the steps below: 1. Connect the Triumph-LS to Internet. 2. Go to Support->Remote Assistance. 3. Set Password and press Connect. 4. Write in this thread the password and S/N of Triumph-LS...

Hello Ryan, If you would like to configure Base TCP Server via WiFi, please follow the steps below: 1. In the TCP Server Configuration screen tap on WiFi button. 2. Set AP SSID, Network Key, select WLAN On, OK. 3. Go to Base/Rover screen, tap on "To Base". 4. Wait until LS will configure Base...

Yes, the T-LS has been updated to the latest Pre-Release version.

We have paired successfully HPT435BT with the Triumph-3: Please use External Radio for working with the Triumph-3 + HPT435BT and Internal if you want to use the internal radio of T-3: We recommend to set the output power of HPT35BT to the highest level in a field:

Could you please: 1. Power OFF the HPT435BT. 2. Connect from T-LS Base/Rover to Triumph-3. 3. Power ON HPT435BT.

Thank you, we will inform you, as soon as finished.

Hello Mr. Simolo, In order to investigate the issue and to find better solution, we would like to ask for a remote session. Please follow the steps below: Connect the Triumph-LS to Internet. Go to Support->Remote Assistance. Set Password and press Connect. Write in this thread...

Hello Darren, Please describe, what do you mean under " hard reset on the LS". If you select "Base Radio - External", the setting will be saved and keep the value after "Turn Off" or "Reboot".

Hello Jason, We would like to investigate the problem remotely, therefore please follow the described steps below: 1. Power ON Triumph-LS, T2 and HPT435BT. 2. Connect the Triumph-LS to the Internet. 3. On Triumph-LS, go to Support->Remote Assistance, set password and tap on Connect button...

Hello Jason, 1.Make sure please, that the HPT435BT has attached antenna. 2. Launch TLS, go to the Base/Rover, connect to T2 via BT. 3. Go to UHF Configuration, make sure that the Output Power is set to maximum value.

Hello Bill, We suggest to investigate the problem remotely, therefore please connect the Triumph-LS to the RAMS by following the steps: 1. Connect the Triumph-LS to the Internet(if possible via Ethernet). 2. Go to Support->Remote Assistance, set password and tap on Connect button. 3...

Hello Bill, It seems, that there is an issue related to antenna switching in J-Field 3.0.5.287 . In order to switch the antenna to external, please follow the instructions below: In Radio Configuration screen select Antenna Input: External, apply. In the same screen Power Off, then Power On...