Adam Davis
Member
Hello all, I've had the Javad Triumph-LS and 1M system for a little over a month and after much trial and tribulation I cannot seem to get the Javad to shoot a single check point consistently without an error of around .06' My current boundary settings are 150 epochs/240 seconds/Only RTK Fixed/Verify with V6 Reset/Confidence Level 15/Confidence Guard .131/.023/Consistency Level 30/Minimum RTK at least 2/Validate ON/Correct for Tilts Off.
I set up my 1M on a known base point (the only one i have used throughout the job) and orient it north. I also orient the LS north. The pole was just calibrated. I am trying to take as much potential human error out of the equation that I can. Maybe I am expecting too much but when I shoot the same monument 2 hours apart the results are .06 different. Granted I have got some shots to be .01-.02 but not with the amount of consistency I would like. Am I missing something? I understand I can take multiple shots and average them out but I am looking to be able to set monuments with the LS in real time and not worry that they are potentially almost an inch away from where I say they are. Sorry for the long winded question, I look forward to any replies! Thank you!
I set up my 1M on a known base point (the only one i have used throughout the job) and orient it north. I also orient the LS north. The pole was just calibrated. I am trying to take as much potential human error out of the equation that I can. Maybe I am expecting too much but when I shoot the same monument 2 hours apart the results are .06 different. Granted I have got some shots to be .01-.02 but not with the amount of consistency I would like. Am I missing something? I understand I can take multiple shots and average them out but I am looking to be able to set monuments with the LS in real time and not worry that they are potentially almost an inch away from where I say they are. Sorry for the long winded question, I look forward to any replies! Thank you!