Alignment Staking function not opening

Greg Flowe

Active Member
I have had this issue when using alignment staking where if you start staking an alignment then get out of alignment function to just stake an independent point, then get back into alignment it works the first time you get back in, If you do the same process again as I described above it will not let you get back into the alignment function. You have to shutdown and restart the LS to make the alignment function work again. This has happened on multiple jobs, not just one particular job. Any solutions or suggestions on what I am doing wrong?
 

Adam

Well-Known Member
5PLS
I have had this issue when using alignment staking where if you start staking an alignment then get out of alignment function to just stake an independent point, then get back into alignment it works the first time you get back in, If you do the same process again as I described above it will not let you get back into the alignment function. You have to shutdown and restart the LS to make the alignment function work again. This has happened on multiple jobs, not just one particular job. Any solutions or suggestions on what I am doing wrong?
Can you send a project to support for investigation.
 
Top