Another DPOS file exceeds 2 days

John Troelstrup

Active Member
Not sure how to post to "Support". I do not see a direct link.
I was on this job about 4 hours but it will not let me DPOS it.
Matt S was kind enough to tell me that most likely I started and connected to my base before it had wiggled itself in.

Here is the link for my Archive

If there is anything else for me to do, please let me know.
Thank you
 

Nate The Surveyor

Well-Known Member
Ok, that is good tech support.... But it begs the question. Is it a bug that causes this problem? What's the underlying problem?
I've not seen this problem posted except with javad gps. Just curious.
N
 

Alexey Razumovsky

Well-Known Member
JAVAD GNSS
5PLS
Ok, that is good tech support.... But it begs the question. Is it a bug that causes this problem? What's the underlying problem?
I've not seen this problem posted except with javad gps. Just curious.
N
Firmware 3.7.2 Aug,2017 isn’t good in 2020. I would recommend 3.7.9 Dec,30,2019.
 

John Troelstrup

Active Member
Thank you Nate, for asking the question and Thank you Alexey for pointing me in the correct direction.
I will go about updating my Firmware as recommended. I was not aware that I needed to do that.

I asume that you are talking about the Firware inside my T1-M base?
Which will probably lead to my next post - How do I do that?
I will research the forum first and try to learn.

Thank you, I do love the Support that this forum and staff provide.
 

Shawn Billings

Shawn Billings
5PLS
Update using Triumph LS connected to internet connected to Triumph 1M. Use base rover setup, button below start/stop base.

Updating modem firmware is different from receiver firmware.

You can also update modem firmware in UHF configuration in base rover setup.
 
Top