Auto increment by 0.1

[T.Guisewhite]

Is there any way to set up a point increment of 0.1

I want to set the LS on a point with auto accept and auto restart 2x so I would collect:
201 201.1 201.2

It does it if I start with a decimal...but not if I start with a whole number.
Thanks!

 

[Adam]

It does it if I start with a decimal...but not if I start with a whole number.

This is how it is designed to work. Some folks don't use .1,.2, etc for redundant points. Some just use whole numbers. I use a mix of the two naming techniques. If implemented it would need to be a setting that could be toggled on/off.

 

[Mike Lacey]

We use the 10.1, 10.2, 10.3 when using auto accept, than after combining the points we assign combined point a whole number (10).

 

[Adam]

That's what I do too.

 

[T.Guisewhite]

So this again goes back to StarNet for me...
I have it set to automatically merge the decimals 10.1 10.2 10.3 into the whole number 10

Then the total station data comes in...boils it all down without touching or editing any raw data.

It would be a time saver if there was a toggle to switch it on...guess that’s what I’m asking for. Can this be included in a later software update?

 

[Adam]

So this again goes back to StarNet for me...
I have it set to automatically merge the decimals 10.1 10.2 10.3 into the whole number 10

Then the total station data comes in...boils it all down without touching or editing any raw data.

It would be a time saver if there was a toggle to switch it on...guess that’s what I’m asking for. Can this be included in a later software update?

Hey Tim, why start with a whole number if it is going to be your final point?