Auto Restart Stopped Working

Jim Frame

Well-Known Member
My regular control profile is setup to collect 1200 epochs then auto-accept and restart. After the most recent upgrade the restart no longer works. I tried changing the setting from "restart 1000 times" to 900 times, to no avail.
 

Adam

Well-Known Member
5PLS
My regular control profile is setup to collect 1200 epochs then auto-accept and restart. After the most recent upgrade the restart no longer works. I tried changing the setting from "restart 1000 times" to 900 times, to no avail.
Do you have an hrms or dist requirement set? If so and it doesn't meet that criteria it won't auto accept. Is it accepting and not restarting or never accepting?
 

Jim Frame

Well-Known Member
It's been almost a week since my initial post. Is anyone on the development team looking into this?

Thanks!
 

Michael Stazhkov

Developer
JAVAD GNSS
It's auto-accepting but not restarting.
Hi Jim. We are changing this part now due to changes in RTPK and we can't reproduce the issue on the development version. Could you send a project to support, I need to look into your settings, may be I missed some variant.
 

Nate The Surveyor

Well-Known Member
I did notice that auto-accept waits until RTPK has finished. In my case, this can take an additional 1-3 minutes. There are pros and cons with this.
Pro is that it spreads out the time frame more, so as to have data more spread out. Cons is that it takes longer to get those 3-5 observations.
It would be good if this were simply users choice. A- “Allow restart before prev RTPK has finished”
Or
B- “Delay restart until prev RTPK has completed”
I personally would prefer A above, for most observations.
B would be fine, on a real hard place, where you leave it and go to lunch.
Thank you
N
 

Michael Stazhkov

Developer
JAVAD GNSS
Any update on this, as ours has the same issue. No automatic restart.
Yes, We have reproduced the issue on the release version. The bug is not exist in our development version. We are thinking which way is the best, try to fix the old version and release again or wait for release of a new version.
 
Top