Zoltan Varga
General Manager of Geomentor Kft
Hello,
My T2 is configured to send out correction via blt-b port. I configured the HPT with ModemVU. I set the MAC address of the T2, changed the mode to Master and turned the BT on. If I turn on T2 and HPT, while I connect NetView to the USB port of T2, I can see on the Ports/Bluetooth dialog, that HPT connected as a Master to blt-a of T2. Of course T2 will not send correction, because blt-b used to do this. How can I set HPT to connect to Blt-b of T2, when no controller connected to blt-a ?
My T2 is configured to send out correction via blt-b port. I configured the HPT with ModemVU. I set the MAC address of the T2, changed the mode to Master and turned the BT on. If I turn on T2 and HPT, while I connect NetView to the USB port of T2, I can see on the Ports/Bluetooth dialog, that HPT connected as a Master to blt-a of T2. Of course T2 will not send correction, because blt-b used to do this. How can I set HPT to connect to Blt-b of T2, when no controller connected to blt-a ?