John Troelstrup
Active Member
After the linux installation, when I locate something by offset (Tree, Bldg ect..) using the Cogo direct function,
The Offset located point now goes on the Design page which does not allow it to be DPOS'd. I did do the Shift and Triangle DPOS button to see if would fix them, but no where close.
I did not have this problem before so perhaps it is a settings tweak that I need to apply. How can I have my offset locates just end up with my regular field data?
Thank you,
John Troelstrup, PSM
The Offset located point now goes on the Design page which does not allow it to be DPOS'd. I did do the Shift and Triangle DPOS button to see if would fix them, but no where close.
I did not have this problem before so perhaps it is a settings tweak that I need to apply. How can I have my offset locates just end up with my regular field data?
Thank you,
John Troelstrup, PSM
