DPOS failed to process this morning, but OPUS didn't have any issue in returning its solution. What's going on with DPOS?
DPOS says: "No CORS in range." Why?
- Thread starter Kelly Bellis
- Start date
DPOS failed to process this morning, but OPUS didn't have any issue in returning its solution. What's going on with DPOS?
FWIW - I resubmitted to DPOS, and this time it worked, thankfully! 
Duane Frymire
Active Member
I processed earlier today, said not enough time or noisy data. But I look at points and they did actually process. But the software stuck with the Auto base position and chose the ppk solutions instead of RTK, but no bcp anything (so I'm not seeing a bcp ppk versus cors ppk as usual). The ppk were within less than a tenth of RTK so looks good. Two points I checked into were within 0.002 of previous known locations so that looks good too. It wasn't an unusually bad base position, and it was there for an hour and 45 minutes. The rtk/ppk were 5 to 20 minutes.
Just tried reprocessing and now "no cors in range", same as you got earlier.
These were yesterday afternoon occupations. Don't see any unusual solar activity. Not sure what's going on.
Just tried reprocessing and now "no cors in range", same as you got earlier.
These were yesterday afternoon occupations. Don't see any unusual solar activity. Not sure what's going on.
David M. Simolo
Well-Known Member
I had the same problem around 10pm EDT yesterday. It seemed to work fine after midnight.
Steve Douty
Well-Known Member
We are getting the same message "no CORS in range". It's nice to say, it will be fixed sometime, soon, maybe; and we go back hours later and everything works. Is there an answer, or solution, or process?
Steve, try switching to the Debug Server. In DPOS, hit the gear button, then Advanced, then switch to Debug server and try again.
Steve Douty
Well-Known Member
Shawn,
Thanks for the rapid response, we will try it next time and report results.
Thanks for the rapid response, we will try it next time and report results.
Duane Frymire
Active Member
Still having troubles with DPOS. The Debug Server has worked, but something still not quite right; I don't get the rover cors processing anymore or the bcp processing. So, tried manually submitting one from the Triumph 2 on the user site. Got the same error of not enough time or noisy data and would not process. Converted to rinex and submitted to OPUS, received excellent results. The CORS in NY are now broadcasting Galileo corrections, could this be confusing the process in some way?