How do I key in Lat/Lon

Nate The Surveyor

Well-Known Member
Into my LS?
I have a job that shows a lat lon on a given point. I can use this lat lon to derive SPC, and then put the rest of the legal desc into it. That's my goal.
Thank you,
Nate
 

Nate The Surveyor

Well-Known Member
I think I've got it.... If not, it should not hurt me, as I've got layer 0 set to WGS84, keyed into the LS a lat Lon.
Layer 1 is local, with all the coords. (Undefined datum, but coords are identical, but this can be moved around, if things are a few feet off)
Layer 2 is NAD 83.
It's a re stake on a cell tower.
The lat Lon is at the middle of the site. Where the tower is to go.
There is little cell signal out there.
If I had figured out how to use the VRS, I doubt it would work here.
We're making a family outing of it. Umbrella, rain, and hurry!
N
 

Nate The Surveyor

Well-Known Member
I will find out via DPOS, after I re stake the job, as there should be ground control, on this site. So.... The only fundamental thing is that the Lat Lon gets me close. If it fails, I will still be able to tie into PLSS cors, and back it in.
Hopefully it won't get that bad. But, I'm a bit jaded!
N
 
Top