Jim Frame
Well-Known Member
I updated to J-Field 3.0.10.402 today, and am now having trouble with exports -- I'm getting some empty folders where there should be data.
After updating I set up a new job and ran base/rover. At the end of the session I downloaded the base file to the LS. One thing that seemed odd is that when I pressed Done I didn't get a message about leaving the Base/Rover screen; I though there used to be an "are you sure" message.
Back in the office I did a Project Archive export to a USB thumb drive, and specified Full (everything except CSV Presets), which is what I normally do. However, when I try to get the base file from the archive (*.zip/Project/JobName/Raw Data) I get a "This folder is empty" message. I was able to export the Star*Net and Text files successfully, but the base file isn't there. I was able to retrieve it from the T2, but that's more of a hassle than grabbing it from the LS.
After updating I set up a new job and ran base/rover. At the end of the session I downloaded the base file to the LS. One thing that seemed odd is that when I pressed Done I didn't get a message about leaving the Base/Rover screen; I though there used to be an "are you sure" message.
Back in the office I did a Project Archive export to a USB thumb drive, and specified Full (everything except CSV Presets), which is what I normally do. However, when I try to get the base file from the archive (*.zip/Project/JobName/Raw Data) I get a "This folder is empty" message. I was able to export the Star*Net and Text files successfully, but the base file isn't there. I was able to retrieve it from the T2, but that's more of a hassle than grabbing it from the LS.