J-Field crash

[Shawn Billings]

Can you connect to RAMS for me?

 

[Donald E Robinson]

I have RAMS, but, I have not used this before. How do I connect?

 

[Shawn Billings]

Make sure that the LS is connected to the Internet. Go to support, Remote Assistance. Make sure Javad server is checked at the top. Enter a password. For now make it 1234. Then press connect at the bottom.

 

[Donald E Robinson]

ok it says its connected

 

[Shawn Billings]

I don't see it Don. Did you press Connect?

Should look like this:

 

[Donald E Robinson]

Its connected going on 15 minutes

 

[Shawn Billings]

Custom Server or Javad GNSS, Inc. Not sure why, but I don't see it.

 

[Donald E Robinson]

Its looks just like your attachment, but, address and port are different.
Is making some sounds

 

[Shawn Billings]

Go ahead and reboot for me. Let's see if that gets it.

 

[Donald E Robinson]

Ok.. Rebooted and connected.

 

[Phillip Lancaster]

FYI! Jfield 2.0.5.50 locks up when I go into DPOS. Once clicked its a restart every time.

 

[Matt Johnson]

FYI! Jfield 2.0.5.50 locks up when I go into DPOS. Once clicked its a restart every time.

Your project archive for that project would be needed to investigate.

 

[Shawn Billings]

I'm not seeing it on my receiver.

 

[Michael Stazhkov]

FYI! Jfield 2.0.5.50 locks up when I go into DPOS. Once clicked its a restart every time.

On the test version it is possible to select sort DPOS tasks by clusters. And if your don't filter DPOS tasks only for current project it can cause this behavior.
I think it is possible to remove the setting through RAMS (Stng/Common/Files/DPOS/Sort/Type=Cluster).

 

[ardian]

1. "Unhandled Errors" Do you recall what you were doing when you had the unhandled errors, Don?

2. "Point Export/Import" When you separated the points at export, how did the export name the survey points? Did it add text (such as "STK_") or did it add a numeric value (such as 1000) to the design point names? Also, just curious, what is your reason from importing the survey point back into the project?

3. "Base Rover Autonomous". Are you entering the coordinate in Base Rover Setup, then pressing OK, then Starting the Base with Start Base and selecting "Yes Store Point and Start Base?"

Hi Shawn,

Your tutorial is nice, what application did you use to record that kind of LS interface?
It would be nice if you can share that application to me

Regards

 

[Matt Johnson]

RAMS and some screen recording software (we use Camtashia) is used to created videos.