Sam Glenn
Member
Not sure if I am posting about something that has already been discussed in other threads. However, this past weekend I updated my J-Field software to version 3.0.9.439. After that update I had two immediate issues that caused some problems.
1. In any profile chosen, if you elected to start RTPK prior to the shot routine completing, it would not store the RTPK shot unless you ran it again at the end of the routine. I spoke to Adam and he said that the bug had been reported, but I wanted to bring it up once again.
2. On a separate job, I was staking to linework and I began to get a screen pop up that said ....... out_of_range: vector::_M_range_check__n (which is 0).= this->...
Once this screen pops up, you are given an option to go back to home screen or Close application. This happened several times and each time I was forced to close the application.
I am attaching the screen shot to this thread along with the crash log. I can send in the project archive, however it says the file is too large to upload.
Any information on this would be great. Thank you
1. In any profile chosen, if you elected to start RTPK prior to the shot routine completing, it would not store the RTPK shot unless you ran it again at the end of the routine. I spoke to Adam and he said that the bug had been reported, but I wanted to bring it up once again.
2. On a separate job, I was staking to linework and I began to get a screen pop up that said ....... out_of_range: vector::_M_range_check__n (which is 0).= this->...
Once this screen pops up, you are given an option to go back to home screen or Close application. This happened several times and each time I was forced to close the application.
I am attaching the screen shot to this thread along with the crash log. I can send in the project archive, however it says the file is too large to upload.
Any information on this would be great. Thank you
