Javad Mobile Program

[Donald E Robinson]

After I get the TR-2 setup for a 2 hour static session and begin collecting data, am I supposed to leave the program on my tablet running? If I do I get some warning tone that I assume, is telling me when I am out of Bluetooth range.

I lost a 2 hr static session because, I guess, I stopped the session by selecting "Close File". There are are no other options on that page(such as 'Back" or "Exit") after the session starts.

If I turn my tablet off, will TR-@ continue to collect data or stop? I don't want to do this again,

I must be getting old because I can't remember from one session to the other what I did. I guess I just closed the program before.

 

[Yuri Noyanov]

Dear Donald,
With JMT you can just start your static survey with required occupation time and receiver stops the survey automatically then the surveying is over. You don't have to be connected to your receiver for all the hours. Also after reconnect to receiver then surveying is on, you can see remain time for the survey.
In any case, surveying goes on even you disconnect your table or turn it off. And you can use FN button in your receiver to stop the survey manually.
Best regards, Yuri Noyanov.

 

[Donald E Robinson]

Yuri,
Thanks for the feedback. I thinks I stopped the session by clicking on "Close File" on the Set-up/Start screen assuming it would act the same as the "Done" button on the Triumph LS set-up screen.