known base points and DPOS

gstjohn

New Member
hello,
new user here with a T3/LS+ setup. i have a data set where i was "leap-frogging" using rtk, that is collecting a point near the limit of my internal radio, then moving the base to occupy the new position and stretching it out another mile, repeat.
on two setups, i identified the base positions as "known points". in my head at that moment, i thought they would be "known" since i had previously observed those positions. now i know that this is for positions that you want to hold the coordinates fixed.
back in the office, it was completely obvious what happened when sent the base positions to DPOS, some of the base positions remained fixed. in the points menu i can see that there are points that do not have an orange open dot pointing to the green dot, i presume implying that they were shifted using DPOS.
Essentially, I have two base positions that i need to identify as unknown so that they can move with the adjustment.
by the way, i was going to send a screen shot. when you hit the print screen button, where does this image go?
Thanks in advance,
Greg St John
Benicia, CA
 

Adam

Well-Known Member
5PLS
hello,
new user here with a T3/LS+ setup. i have a data set where i was "leap-frogging" using rtk, that is collecting a point near the limit of my internal radio, then moving the base to occupy the new position and stretching it out another mile, repeat.
on two setups, i identified the base positions as "known points". in my head at that moment, i thought they would be "known" since i had previously observed those positions. now i know that this is for positions that you want to hold the coordinates fixed.
back in the office, it was completely obvious what happened when sent the base positions to DPOS, some of the base positions remained fixed. in the points menu i can see that there are points that do not have an orange open dot pointing to the green dot, i presume implying that they were shifted using DPOS.
Essentially, I have two base positions that i need to identify as unknown so that they can move with the adjustment.
by the way, i was going to send a screen shot. when you hit the print screen button, where does this image go?
Thanks in advance,
Greg St John
Benicia, CA
Tap on the base points in the point screen and tap the chart button in the upper right area of the screen. Then change the base to cors processed.

Manual Screenshots can be seen from files, then collected by user. For point screenshots select by point.
 
Top