LS+ Locked-up/Frozen

briarcutter

briarcutter

Member
Yesterday will out working, my LS+ screen locked-up/froze. It took almost 2-min of holding the power button down for the unit to shut off. Once re-booted it did not recognize the existing setup. I went back to the base and tried to re-connect. While doing so, most of my UHF settings had changed: the modulation band, the frequency, the format and the reference frame had changed to WGS84(ITRF2008). I am able to change all of the settings except the reference frame ... can someone help with finding the location for this setting. I am still running the pre-4.0 version.

I also found that other things had also changed: Projects were now listed in chronological order instead of alphabetically and the screen "time-out" setting had changed

Any help would be appreciated ... thanks in advance ... Paul
 
Phillip Lancaster

Phillip Lancaster

Active Member
Update to the new version. I think the coordinate system is set when you start the job. Then when you go to set the base by the base point coords/base height there is a setting there for reference frame.
 
You must log in or register to reply here.
Top