Charles Owens
Active Member
The unit was on and temporarily not in use. It went into sleep mode (I guess) and now it will not wake up. Nothing on the screen. Trying to power off but getting no response at all.
LS locked up...
- Thread starter Charles Owens
- Start date
Hold down the On/Off key for 10 seconds to force it off. Then you can turn it back on.
Charles Owens
Active Member
That seems to have done the trick. Thanks
Another question..
I have done a localization and collected a point in project coordinates (50K,50K). I can see the project coordinates using the points command. How do I view/export the underlying grid coordinates for this point?
Another question..
I have done a localization and collected a point in project coordinates (50K,50K). I can see the project coordinates using the points command. How do I view/export the underlying grid coordinates for this point?
Change the coordinate system of the current page to that underlying coordinate system.
Charles Owens
Active Member
I think I knew that. Just needed a push in that direction. Thanks
Bill Eggers
Active Member
While using Stakeout today and staking points, I was saving points and for my "accept as" adding 1000 to my design point number.
First off, the accept as was always the same as the previous shot, is there any way to either have it automatically increment to the next highest or, better yet, store with a certain increment like my adding a 100o to design point?
Second, while editing the accept as, apparently I acquired enough data to accept the shot. This was accompanied by having a "create" tab popping up at the lower right of the screen. When I selected this rather than using the back button, I was returned to the stake screen which was then locked up and unresponsive. I then had to hold down the off button to force off. This happened twice and I learned my lesson to always back out of this screen.
First off, the accept as was always the same as the previous shot, is there any way to either have it automatically increment to the next highest or, better yet, store with a certain increment like my adding a 100o to design point?
Second, while editing the accept as, apparently I acquired enough data to accept the shot. This was accompanied by having a "create" tab popping up at the lower right of the screen. When I selected this rather than using the back button, I was returned to the stake screen which was then locked up and unresponsive. I then had to hold down the off button to force off. This happened twice and I learned my lesson to always back out of this screen.
Bill Eggers
Active Member
Following on my last post, after saving over twenty points as staked, only about 5 show up as surveyed.
Since there were only this few, I tried running DPOS on my base. Now about a third of my design points indicate that they have been base cors processed and they have been moved to new locations. (about 3 feet different). Only three of my surveyed staked points show up.
I was working off a known point for a base with my T2.
Since there were only this few, I tried running DPOS on my base. Now about a third of my design points indicate that they have been base cors processed and they have been moved to new locations. (about 3 feet different). Only three of my surveyed staked points show up.
I was working off a known point for a base with my T2.
This is what should be happening, if it is not then there is some bug.
I am not able to reproduce this bug using the latest version of J-Field with Linux. If you have it happen after upgrading to Linux let us know.
Are you able to upload a project archive of this project to Dropbox or Google Drive and share a link to it?
Jim Frame
Well-Known Member
Are bugfixes for Windows versions no longer being pursued? Is a stable Linux version imminent?
Unless it is a critical bug, Windows bug fixes will probably not be pursued. A Linux OS and J-Field version is very close to be ready I feel. There will likely only be one more Windows release which add a tool that automatically migrates the OS and J-Field to Linux.