LS Turned Off While Recording Points & Coordinate Systems Disappear

Brad Thompson

New Member
We were in the field yesterday on a 55 acre parcel of land using MDOT (Michigan Dept. of Trans.) CORS and on two separate occasions the LS turned off while recording a point. I was able to restart the unit and continue working. I checked back into a few points that we recorded both earlier in the day and on previous occasions and they were well within tolerance. Has anyone else had this issue? Also, this morning I attempted to create a new job and all of my coordinate systems have disappeared. We normally use the "Unknown" coordinate system to localize to our specific job, i.e., 5000,5000, which WGS84 will not allow us to use (not lat. & lon.). I have attempted to create another "Unknown" coordinate system but when selected it does not appear in the system list. Unfortunately, we are dead in the water until this problem can be solved!
 

Matt Cotterman

New Member
I've had the same issue with the missing coord systems & "unknown" not showing up. When you are in the screen assigning the coordinate system click the top of the screen and it will scroll between "All Projects Coordinate Systems", "Current Project Coordinate Systems" & "Default Coordinate Systems". If it is set to "Default Coordinate Systems" you will not see the "unknown" system you created. I wasted a good hour in the field trying to create a coordinate system until I fat fingered the top of the screen and suddenly the 30 coordinate systems I had created appeared. It's actually a nice feature now that I figured it out.
 

Brad Thompson

New Member
I've had the same issue with the missing coord systems & "unknown" not showing up. When you are in the screen assigning the coordinate system click the top of the screen and it will scroll between "All Projects Coordinate Systems", "Current Project Coordinate Systems" & "Default Coordinate Systems". If it is set to "Default Coordinate Systems" you will not see the "unknown" system you created. I wasted a good hour in the field trying to create a coordinate system until I fat fingered the top of the screen and suddenly the 30 coordinate systems I had created appeared. It's actually a nice feature now that I figured it out.
That did it! Same as you, I must have spent an hour before finally posting this! Thanks!!
 

Vladimir Prasolov

Well-Known Member
JAVAD GNSS
I'm very sorry. The initial request was to reduce number of systems in the list. So we created those groups and selected "All Projects Coordinate Systems" as default. I think it would be good to add special sign on the right of that button to mark it as toggle. We will do that to simplify usage. Thank you.
 
Top