Mobile Tools for Android: Can't connect on WiFi

JVan

Member
I am running Mobile Tools v1.3.0 Build 12/26/14. I can connect to my Triumph2 with no problems over Bluetooth, but can't over Wifi (with MobileAP) or Network. I click on the bluetooth configuration, then "Reconnect with WiFi", but it never shows up in the green list although my phone does show that the Triumph2 is connected to the phone's AP.
 

Joy Chiu

New Member
1. connect to NET View /paramters/networking/WLAN Setting

2. Send

%%set,/par/net/wlan/ap/ssid,HTC (You android wifi name)

%%set,/par/net/wlan/ap/key1,1111

%%set,/par/net/wlan/ap/key2,1111

%%set,/par/net/wlan/ap/key3,1111

%%set,/par/net/wlan/ap/key4,1111

%%set,/par/net/wlan/ap/passphrase,23017718(You android wifi ap password)
 

Attachments

  • 熱點連接.png
    熱點連接.png
    172.3 KB · Views: 398
  • 熱點連接.png
    熱點連接.png
    172.3 KB · Views: 399

Yuri Noyanov

Active Member
JAVAD GNSS
Dear JVan,
please see attached document about WiFi connection.
Best regards, Yuri Noyanov.
 

Attachments

  • WiFi Connection.docx.zip
    727.6 KB · Views: 382

JVan

Member
Doesn't work.
T2 connects fine to my phone's mobile hotspot (my phone shows it connected, and the T2 wifi indicator turns green). In JMT I connect to T2 via bluetooth and select "Reconnect With Wifi", T2 resets itself but JMT never connects and just goes back to the "select a configuration" screen. T2 never shows up on the green list.

'bout ready to chuck this stupid T2 through the window. NOTHING has been as easy as the marketing material makes it out to be.
 

Yuri Noyanov

Active Member
JAVAD GNSS
Dear JVan,
you seem to be right - it is not so easy. For Mobile Hot Spot mode your mobile phone should be configured as described - encryption should be removed. And after a change in WiFi receiver should be reset. And then you can use JMT to configure rover receiver. I just added another mode for JMT - then T2 and your mobile phone connect to existing wifi access point. In the mode they can exchange data through the access point. I added the mode into JMT 1.5.10 beta. And going to add connect to WiFi in addition to connect to WiFi AP. May be even I will put a separate item to configure receiver for WiFi with more information and progresses.
Thank you for the opinion, that motivates to make things better.
 
Top