Darren Clemons
Well-Known Member
I think this has been changed in the new update of J field and I'm hoping it was by accident. When I go to move a group of design points I select for instance design pnts 1-10 and then move design pnt 1 to survey pnt 12. Then typically after finding another design pnt and shooting a new survey pnt on it I'm ready to rotate. Now, when I go into rotate I have to re select the design pnts 1-10 again. The same group I chose in move should be held when I go into rotate and I'm fairly sure it was until this new version.
Is there any reason this has been changed intentionally? I can't think of many scenarios where you wouldn't want the same group of points to rotate that you just moved. If for some reason you did you could change the group that's already pre set in that screen.
Also, is there any way that the filtering icon could be "separated" from the design point side to the survey point side? What I mean is, usually I only use the filter in design points. I know it's sometimes needed on the surveyed side as well so I don't mean to eliminate it, just somehow have a separate one for each screen.
I may have 30 design points but only be ready to move/rotate 10 of them so I go to the filter and type 1..10 and then those 10 are all that's on the screen under design. I can then select the all points icon on top left.
However, then when going into surveyed points to select which surveyed point to move "to" that filter is still "active" where it shows no surveyed points. Unless there's an easier way, I have to hit the filter again, click on the number I'd previously put in 1..10, and then clear it out of the keyboard. Only then do all my surveyed points reappear.
Am I missing some way to just easily toggle off the filtering?
Is there any reason this has been changed intentionally? I can't think of many scenarios where you wouldn't want the same group of points to rotate that you just moved. If for some reason you did you could change the group that's already pre set in that screen.
Also, is there any way that the filtering icon could be "separated" from the design point side to the survey point side? What I mean is, usually I only use the filter in design points. I know it's sometimes needed on the surveyed side as well so I don't mean to eliminate it, just somehow have a separate one for each screen.
I may have 30 design points but only be ready to move/rotate 10 of them so I go to the filter and type 1..10 and then those 10 are all that's on the screen under design. I can then select the all points icon on top left.
However, then when going into surveyed points to select which surveyed point to move "to" that filter is still "active" where it shows no surveyed points. Unless there's an easier way, I have to hit the filter again, click on the number I'd previously put in 1..10, and then clear it out of the keyboard. Only then do all my surveyed points reappear.
Am I missing some way to just easily toggle off the filtering?