New video showing LS+ and RTPK

Adam

Well-Known Member
5PLS
Excellent job Matt. I noticed it fix with 2 engines for several seconds in your video. When I see that happen I stop it and accept it. I haven't seen a bad one with 2 engines that lasted for more than 2 or 3 seconds and usually if it is bad it will fix with 2 then go right into a float solution. I may end up with 2 or 3 shots I've saved with 2 engines and 2 or 3 that are rtpk and rtk with 1 engine and 240 seconds or more of time. Has anyone seen a 2 or more engine fix, with all four constellations being used, that lasted at least 5 seconds be wrong?
 

Matthew D. Sibole

Well-Known Member
5PLS
I use a confidence level of 15, consistency of 20, mi. RTK engines set to 1 and validate turned on with 1 engine. Count up to a total of 240 epochs. Auto repeat 2 times and auto accept turned on.

I did use the same profile when using my standard LS with multi-constellation.
 

avoidthelloyd

Active Member
Thank you for doing this. Keep making them. I've found that if my LS+ collects an epoch or two but then stalls, long pressing the RESET ENGINES button along with AUTO SETUP helps me a lot of the time.
 
Matt: In reviewing your very helpful video again, it appears that when you have a completed, acceptable RTPK solution while RTK is still running, you hit STOP and immediately accept the shot without waiting for the new RTPK routine to complete itself. Does that mean that you store the last completed RTPK shot with the RTK? I've been waiting for the 'final' RTPK routine to finish before accepting the shot; perhaps this isn't necessary?
 

Matthew D. Sibole

Well-Known Member
5PLS
I do generally stop and accept the shot after I get a RTPK shot that agrees. I do not generally let the last RTPK session process. There is a chance that the last RTPK session may come up with a different solution and I do not want to take that chance.
 
Top