PreRelease 4.0

Mitchell D Lane

Active Member
20220227-04.01.05_1014[1].png
 

giulio

Member
Failing to configure wi fi on t-3, even following the instructions on page 34 (NetViewModem_Software_Manual.pdf), in these we refer to "See detail description in [2, 4.4.25 Network Parameters (WLAN (WiFi) Configuration)]." Any of you know in which help file these descriptions are found?
 

giulio

Member
a question being connected to jcors and with the rover I know that I will be in a position where the radio is not needed, you can turn it off on the t-3, thus saving the batteries, if so how do you proceed?
20220302_230348.jpg
 

Attachments

  • 20220302_230348.jpg
    20220302_230348.jpg
    128.9 KB · Views: 170

Matt Johnson

Well-Known Member
5PLS
Before you start the base tap on the bottom left hand side and uncheck the radio option.

Base settings can now be changed after the base has been started. This does not have to be done before the base is started. You can start the base with the radio and then later turn it off.
 

Sdrake14

Active Member
Gentlemen there appears to be a problem when using the pre-release on an LS as the TCP base. I loaded the PR on both my base and rover, base using a LAN connection checked all the port settings on both receivers, the base always showed 1 connected client when the settings were right, but no corrections were being received.

I then reverted the rover back to Recomended, same results. Reverted base back to Recommended, immediately getting corrections as before.

Then moved the Rover back to pre-release, corrections being received.
So it appears something is off for using the LS as a TCP base...
 
Top