Yes put it in pre-release on RAMS.
Ls and T2. I need to update the radio firmware before updating to 4.0? Is that correct?
In the field LS connected to T2. Set up on point and the epochs continue. Any idea why it starts but does not stop?J-Field 4.0 will be moved to PreRelease soon. This version has some significant changes that you must understand before attempting to use it. The J-Field 4.0 Migration Guide is now available for you to read.
I can start the T-3 using JMT and setup the desired protocol and modulation, just cant seem to do it from the LS.How do you change the radio protocol on the base from the LS+? On the previous version there was an option to configure the base based on the rover settings and another to configure the rover based on the base settings. I can change to the protocol on the rover, but I do not see a way to change it on the base. The default is "Javad". Sometimes I need run two rovers off the T-3 base, but the second rover is a topcon hiper vr.
How do you change the radio protocol on the base from the LS+?
Finally and most importantly, I strongly prefer the Codes list in the old grid form rather than the new list form. I often used the Select Code from List> button as a second page of favorite codes. Between code profiles and selecting a category of codes to shown on the list, I could set it up so that no matter which kind of points I was collecting I could find the code I needed with a click or two. The funnel button is there, but it takes more clicks, it doesn't show which category is selected (just a red funnel), and 25 big buttons per page is way nicer in the field than 10 tiny buttons. Perhaps grid view or list view of codes could be a setting similar to how Windows can show files as large icons or details.
Please don't remove Data Exchange! I use it every time I bring the LS back into the office.It could replace the TLS2TLS button, which could move to Home Page 2 and bump Data Exchange off
Yes.Are the white button settings stored in the UI Profile?
We will add the possibility.Could Localize be assignable to a hardware button?
The map screen has 5 customizable buttons on the right side. We will add the "Center on Current Position" to the list of custom commands.I like the new Map button and screen. It needs a "Center on Current Position" button
We will think about it. Redesign of Collect / Stake and other map screens is in our plans for future releases.I like the new Map button and screen. It needs a "Stake selected point" button that changes to "stake selected line" when a line is selected. Come to think of it, the map on the Collect screen needs that functionality too.
Done (Setups: margins, signals, coordinate systems, antenna height / Localization).Could Localize be assignable to a hardware button?
Done (optionality by long click on the Back button or one of the customizable buttons).I like the new Map button and screen. It needs a "Center on Current Position" button...
Please don't remove Data Exchange! I use it every time I bring the LS back into the office.