Release 3.0.11.802

Nate The Surveyor

Well-Known Member
I'm a 2 engine user. Does this update affect the engine side of the software? Or just the data handling, separate from the GPS engines?
Thx
N
 

Greg Flowe

Active Member
What changes if any other than the wifi/cellular change do I need to make when I upgrade to current release or should everything come in and work the same?
 

Jim Frame

Well-Known Member
I noticed that pressing the power button defaulted to Reboot rather that Turn Off the first time I used it after the update, but thereafter it reverted to the more familiar behavior.
 

Adam

Well-Known Member
5PLS
Actually, I thought of another change that may occur. The variety setting in any profile using variety will be defaulted to 0. Ya'll will need to reset it too.
 

Adam

Well-Known Member
5PLS
There are also some changes to the default white and black boxes. If you were using the black box to the left of start for point name you will have to change it back to point name or use another spot for point name...
 

Adam

Well-Known Member
5PLS
For those using TCP or VRS you must go to either the WIFI or LTE icon and select RTN at the bottom and hit stop and then restart it for it to start getting corrections.
Also, I just updated an LS that was on release 402. It changed the rtn and tcp profiles to uhf. I thought this issue was fixed but it appears to have crept back in. Check all tcp and rtn profiles for this change.
 

Adam

Well-Known Member
5PLS
To make these changes, toggle thru the general group settings.

Select the correct Corrections method here. In this screenshot it had defaulted to UHF/SSP. Change it to Real Time Network.

Wizard Screen_20210630-16.48.51.png



Then select the apn and tap the pencil button. Notice it says Cellular to the right in the blue box beside interface. This is fine if you use the internal cell modem on the LS but if you use wifi you must set it.

Wizard Screen_20210630-16.50.04.png


In the RTN Interface screen select the one you use...


Wizard Screen_20210630-16.51.33.png
 

avoidthelloyd

Active Member
To make these changes, toggle thru the general group settings.

Select the correct Corrections method here. In this screenshot it had defaulted to UHF/SSP. Change it to Real Time Network.

View attachment 11518


Then select the apn and tap the pencil button. Notice it says Cellular to the right in the blue box beside interface. This is fine if you use the internal cell modem on the LS but if you use wifi you must set it.

View attachment 11519

In the RTN Interface screen select the one you use...


View attachment 11520
This is going to show my ignorance, but where the heck is that RTN Interface screen?
 
Top