Nate The Surveyor
Well-Known Member
OK, boundary settings.
Start with START button.
Stop after 120 Epochs
Minimum duration, 200 seconds.
Verify with V6 Reset, YES
Confidence Level 10
Minimum engines 2
IF it is in a challenging place, and it gets 5 epochs, into ONE group, (total number of groups is 25!)
BUT, 2 of those happened in the first minute, and one happened in the 3rd minute, at 190 seconds, and 2 more happened at the 215 second mark.
We now have SEPARATION between FIRST and LAST epoch, at the 215 second mark.
At this point, it should be allowed to go to phase 2. Where it goes to 120 epochs, (for the min epoch count of 120)
Then, at the end of 120 seconds, it COULD skip phase 3, because it has the separation, already during phase 1. This can be done manually. (I've done this, and then started another for additional redundancy.) But, IF it is set to automatically restart, this would be ok.
Or leave as is, and let it do it's final reset, and now we have HIGH confidence.
It's rolling around in my head.
What goes on in your head?
Nate
Start with START button.
Stop after 120 Epochs
Minimum duration, 200 seconds.
Verify with V6 Reset, YES
Confidence Level 10
Minimum engines 2
IF it is in a challenging place, and it gets 5 epochs, into ONE group, (total number of groups is 25!)
BUT, 2 of those happened in the first minute, and one happened in the 3rd minute, at 190 seconds, and 2 more happened at the 215 second mark.
We now have SEPARATION between FIRST and LAST epoch, at the 215 second mark.
At this point, it should be allowed to go to phase 2. Where it goes to 120 epochs, (for the min epoch count of 120)
Then, at the end of 120 seconds, it COULD skip phase 3, because it has the separation, already during phase 1. This can be done manually. (I've done this, and then started another for additional redundancy.) But, IF it is set to automatically restart, this would be ok.
Or leave as is, and let it do it's final reset, and now we have HIGH confidence.
It's rolling around in my head.
What goes on in your head?
Nate