SBAS Code Diff Position

Sdrake14

Active Member
Latest. Was using stable, it worked. Upgraded due to ongoing wifi breaks, then tge position error. Now it will not position in either version. (even if I downgrade it)
 

Sdrake14

Active Member
yes it tracks. just does not compute a position. it will even send corrections to the rover?? But also after a rtk session on saving the base file and submitting it to dpos it gives "invalid gnss file" message. And regardless of how submitted, by jfield or stand alone submittal.
 

Sdrake14

Active Member
the rtk correction apparently based on the position uploaded when starting the rtk session for if I reinstall the firmware or clear navram the reciever position stays at 0.
 

Sdrake14

Active Member
looks like this:
Capture1.PNG
Capture2.PNG
 

Phillip Lancaster

Active Member
Its not tracking satellites at all. Ive had this happen to me but a nvram clear fixed it. I would reinstall latest firmware again. Its gonna work. Maybe got a bad upload on last upload.
 

Sdrake14

Active Member
Philip I just did...again. I went down to stable....nothing. Then up top beta...nothing. Then back to latest, clear nvram...nothing.???
 

Phillip Lancaster

Active Member
Look at tracking time. Its not tracking. As for correction. I guess you are sending nothing via radio. In my mind youre just opening a door with nothing to send.
 

Sdrake14

Active Member
It is going TCP/IP and curiously I get a fix and the position on the rover comes out right. I can stake a previously located point...new file.
 
Top