Settings for sats on T2

[Sven]

When viewed in Net View under Parameters/Main, 'Lock Systems', 'Lock Signals' and 'Position Signals' check-boxes are greyed out (not editable) and empty (and in Sat settings in J Mobile).
'Position Systems' is the only group that is editable.
I'm getting all the satellites selected in Position Systems and good fixes so it doesn't seem to be a problem but I am curious to know why.
T2 firmware 3.6.15, board v.5

 

[Natalia]

Hello Steven. I apologize for the delay. Gray box means that the parameter does not support by the receiver or firmware. 'Lock Systems', 'Lock Signals' and 'Position Signals' parameters were added to the latest version firmware 3.7.9.

 

[Sven]

Thanks very much Natalia. I hadn't realised there was a later version. I will upgrade.