John Thompson
Well-Known Member
I started a new job today that covered several square miles of rough terrain. Some points had no cell signal but were within UHF range of the base. Others were just out of UHF range but had cell signal. The base was on a new control point so I wanted a long duration base file for DPOS and I didn't want to stop and restart the base. A few questions.
1. Is it possible to make the T3 base transmit corrections on UHF and TCP at the same time?
2. Is it possible to stop and restart the base without interrupting recording? Or start a second correction stream without stopping the base?
3. Is it possible to stitch multiple base files together before sending them to DPOS?
1. Is it possible to make the T3 base transmit corrections on UHF and TCP at the same time?
2. Is it possible to stop and restart the base without interrupting recording? Or start a second correction stream without stopping the base?
3. Is it possible to stitch multiple base files together before sending them to DPOS?