Stuck on "3. Applying Rover CORS-Processing..."

[Adam Davis]

I posted this question on another thread but no one was able to help my situation. I went to DPOS a job that I worked on two days ago and my LS was stuck on "3. Applying Rover CORS-Processing..." for about twenty minutes. I tried it again earlier this morning on a separate job with the same result. I tried the DEBUG Server option with no success either. Also when I cancel the DPOS it gets stuck on "1. Data Analyzing..." and the only way to get it out of that screen is to reboot. These are the first two jobs I have done since the latest update and I cannot finish the jobs until I can get the DPOS to run the full way through. Any suggestions?

 

[Adam]

Any particular reason for using Rover Cors processing? You can turn that off in the settings screen for dpos and try it.

 

[Adam Davis]

I don't really have an answer for that other than it's been that way since I started using the LS, I'll give it a shot and let you know, thanks for the feedback. I'm mostly interested in it completing the process and automatically shifting my points so I can get a true base point on the grid.

 

[Adam]

You don't need to use rover cors processing for that.

 

[Adam Davis]

Do you think I should use the DEBUG server option?

 

[Adam]

Try both

 

[Adam Davis]

I tried it first without the DEBUG option and it worked! Thank you so much! Big weight lifted off my chest!

 

[Steve Douty]

Any particular reason for using Rover Cors processing? You can turn that off in the settings screen for dpos and try it.

I think using the Rover/CORS processing is another check. I know that the Rover/CORS solution very seldom yealds a "good" solution because of time on station; however one more check is always good. I have three rear view mirrors, and a back up camra.