T1M Upgrade

Ryan

Member
After updating the OAF on my T1M for the new constellations, what else do I need to do to get my base using the new sats? This is what I'm seeing under "Base GNSS Status"
IMG_20200808_122312.jpg


The LS seems to be tracking the new constellations.
Thanks
 

Phillip Lancaster

Active Member
go into netview and check the box by the constellations and remember to hit apply.
Parameters, Positioning, Main then check what you got.
 

Ryan

Member
It's been a long while since I've used Netview. I downloaded the X64 manual update version 2.2.3.7, plug in the usb cable to reciever first, then
PC, open Netview and power on reciever. Connection mode is set to: Receiver. I clicked the connect button next to COM1 and COM2 and I get "reciever not found" message.
What am I doing wrong?
 

Shawn Billings

Shawn Billings
5PLS
You don't need Netview and modem for anything.

See this thread:
 

Ryan

Member
You don't need Netview and modem for anything.

See this thread:

I have seen it and followed the instructions. I just thought I would see the base tracking more than 2 constellations under "Base GNSS Status".

Thanks
 
Top