TLS Stand Alone Settings Messed Up

[Donald E Robinson]

I don't know what happened but I normally set my TLS, in Stand Alone (static), to collect 10800 epochs (3 hours), but, it only collects data for 18 minutes.
I did notice that t was clicking very rapidly, not 1 per second as it did normally. The epochs were registering 1 per second, which was normal. My setup settings have not been changed since my last session. I tried to adjust my settings, but, no change.

Any ideas of what happened and how to fix this?

 

[Adam]

I noticed this a while ago and reported it. It was storing at 10hz so you met your epoch count quickly. I haven't done a static session with the LS since the base setup started recording the data automatically. I thought it had been changed back to 1hz. Which version of JField? I would recommend using the start/stop button for static sessions so it will collect until you stop it.

 

[Donald E Robinson]

I noticed this a while ago and reported it. It was storing at 5hz so you met your epoch count quickly. I haven't done a static session with the LS since the base setup started recording the data automatically. I thought it had been changed back to 1hz. Which version of JField? I would recommend using the start/stop button for static sessions so it will collect until you stop it.

JField version 3.0.8.428, which is the latest version, I believe.
18 minutes equals 1080 epochs at 1 epoch per second, not 10800. I thought, I might have entered the incorrect number, but, I checked and it was set at 10800.

 

[Adam]

Yes, it is recording at 10 times that. I had edited my original post just a few minutes ago.