Clifton Keith
Active Member
I have an 83 Acre topo to do. Some in the open and some in the woods. What is the best way to setup the LS?
Thanks. Why is verify with resets off?
When doing a topo I normally stake to a line to give me some sort of a grid. Using this method I think I will get all that unnecessary info in the points list.In the open, over smooth terrain, you might want to explore using the above settings with the exception of:
Start when Lifted
Auto Accept: ON
When you get to a point to collect, you plumb the receiver up and it starts without any button presses. Then it collects for the 20 epochs described above. Then it automatically stores the collected point without any user interaction. This is great if you aren't changing the description very often and are just collecting lots of similar points. I wouldn't recommend this for uneven terrain that requires you to stop and step over obstacles as it may start recording when you didn't intend for it to do so. Also, I would not use auto accept in challenging environments with the verification turned off as I described above. You want to be able to decide from the LAST values whether the shot is acceptable or not, so you need the choice.
Using this method I think I will get all that unnecessary info in the points list.
When doing a topo I normally stake to a line to give me some sort of a grid. Using this method I think I will get all that unnecessary info in the points list.
When doing a topo I normally stake to a line to give me some sort of a grid. Using this method I think I will get all that unnecessary info in the points list.