JohnNutkins
New Member
Looking to see if anyone else has experienced this and hoping for a possible solution...
I have an LS+/1M and a LS+/T3 that I use regularly in large tracts, with heavy canopy. I typically set up my base and use UHF to make my measurements until I lose UHF signal, in which case, I typically switch to Wireless LAN(VRS) if I have cellular service. On both of these rover/base setups, I have had occasions that I can't pick up the radio signal after switching to Wireless LAN, even when returning to the base. I have to stop and restart the base in order to get have UHF connection again.
I have an LS+/1M and a LS+/T3 that I use regularly in large tracts, with heavy canopy. I typically set up my base and use UHF to make my measurements until I lose UHF signal, in which case, I typically switch to Wireless LAN(VRS) if I have cellular service. On both of these rover/base setups, I have had occasions that I can't pick up the radio signal after switching to Wireless LAN, even when returning to the base. I have to stop and restart the base in order to get have UHF connection again.