Recent content by Steve Hankins

Josh, you can also toggle the White Boxes with a long press on the compass button from the collect or stake screens.

Just a guess. From "Home" screen, tap" Setup", then tap "General", then tap "Antenna". Is it possible under the "Antenna" screen "Measured Height" is set to something other than 0.0 ft., or is there a "Vertical Height Offset" in that screen set to something other than 0.0 ft. Also check under...

Michael, I don't work in your area, but just a guess, maybe either no Geoid model loaded with your projection , or a incorrect model loaded? Try geoid18_conus.

Just a note. I was unable to upgrade through NetView/Modem, most recent version, trying to use the download firmware, but was able to upgrade through Netview/Modem from the server once I ran it as Administrator. I am running Windows 7 Professional. Thanks to Phillip Lancaster for the tip!!

I am on Chrome, and RAMS is working for me today!

Jim, I am on the Standard LS, all is well.

Nate, I have been on it for a while, and have been pleased. I am not aware of any issues,

Same thing happened to me today with a user in California. Must be an issue on the JAVAD side, not the LS? Thanks for posting.

Jim: I would suggest the antenna change first, and see what results you get. I have seen this make a profound difference.

Just a couple of guesses. (1). Maybe try holding the power button and the record button at the same time until the lights start blinking, hold for a few seconds after they blink, then release. (2). Connect T3 to NetView Modem, I think you can clear NVRAM from there. I do not have a T3 so I am...

Good morning. I checked mine with a multimeter for continuity, and it returns the positive connection wire connects to the "Left" terminal of the connector as viewed from your photo. Best of luck. Steve

Nate: Give me a call, I am in the office today, and we can walk through it.

Mark, if the hard reset does not fix your issue, and you would like to "Reset the Factory Image", just give me a call at 501-620-0608 and we can walk through it.

Jim, I run the LS standard with a T2, and ArDot RTN, and have been on the new release for over a month. Other than learning to navigate the new interface, (read the white paper), I have had solid results on my setup.