Latest activity

  • R
    Ryan replied to the thread 1M Radio Issues.
    I guess I spoke too soon. Cleaning the connection did not fix the issue. It worked for a couple hours and then went back off. I ordered...
  • Matt Johnson
    Matt Johnson replied to the thread 3.0.0.199.
    Is it just not being plotted in the plots or do the values for the groups not change either? I know in version 3.0.1.26 epoch plotting...
  • Matt Johnson
    This was with GNSS 3_6_13b0_rtk4 firmware on the Triumph-2 and the J-Field 2.1.0.58 on the Victor-LS. For the Triumph-2 there are 2...
    • 1534254335538.png
    • 1534254462622.png
  • Wes Cole
    Wes Cole replied to the thread North Carolina RTN.
    I have also been seeing unusual differences in RTN elevation on the network over the past couple of weeks. A project last week had...
  • Andrey Antonov
    Yes, Matt i think calibration is good. Can you please tell me your version firmware on Triumph-2 and version J-Field?
  • J
    jack newsome replied to the thread 3.0.0.199.
    Yes, I have seen this behavior, and have been wondering what is going on with that too.
  • Darren Clemons
    Darren Clemons replied to the thread 3.0.0.199.
    Ok, I’ve been having that issue as well. We have one unit that is doing quite a lot of “getting epochs” - we can here the pop - but...
  • Darren Clemons
    If “Javad” UHF protocol is being used, the rover will still work and receive corrections even if the modulation setting does not match...
  • Matt Johnson
    Matt Johnson replied to the thread Screen freeze with Linux.
    It is best to use Javad protocol unless you are using the radio with some other brand of equipment. With Javad protocol the rover can...
  • Jim Frame
    Jim Frame replied to the thread Screen freeze with Linux.
    Does this mean that Javad protocol should always be selected, or is something potentially lost by not entering a specific match?
  • Clay Davidson
    Clay Davidson replied to the thread Screen freeze with Linux.
    Thanks guys
  • Clay Davidson
    If “Javad” UHF protocol is being used, the rover will still work and receive corrections even if the modulation setting does not match...
  • Clay Davidson
    You change the LS settings under setup and edit the general group profile at the top left. Enter through the screens until you come to...
  • Matt Johnson
    Matt Johnson replied to the thread Screen freeze with Linux.
    If “Javad” UHF protocol is being used, the rover will still work and receive corrections even if the modulation setting does not match...
  • Matt Johnson
    Matt Johnson replied to the thread 3.0.0.199.
    No, it is an issue with the touchscreen of some units when clicks are registered without the touchscreen being physically touched.