Matt Johnson

Its possible the data issues are also related to this.

What time did you end the observation yesterday? It needs to be before 12:00 AM UTM time (8:00 PM EST) for data to be available today.

Is the project from today? You need to wait until the end of the day for data to be available

This sounds like a hardware issue that would need an RMA to fix. You can assign action you may need to the U1 - U4 buttons in Setup >...

I wanted to provide an update on my WiFi setup. I purchased a Cudy Outdoor AP 1.0 and 100ft PoE wire connected to my Fios Router. I...

Make sure that the 'Antenna Type' is selected and the APC offsets are correct in the configuration. These values will then be saved in...

Auto did not work properly for some reason and it was not able to determine the antenna model to use. Notice the antenna model field is...

Is the Eero router connected directly to your internet modem?

I had to enable Auto IP to get it to connect at first. I was able to connect through the local network but not from your external IP...

I’ll take a look if you connect. Start Base should change to Stop Base when the base is started

In your screenshot it doesn't appear the base was started. If you can't connect try connecting the LS to the same wifi network and...

I suspect the issue here is that your main network uses 5 GHz signal. The T3 supports 5 GHz (802.11a) but the LS does not so if you are...

See https://support.eero.com/hc/en-us/articles/207908443-How-do-I-configure-port-forwarding

This can be done through Remote Base in J-Field or with Netview. Auto IP should be disabled and an IP should be assigned so that the IP...

You can transmit corrections through TCP using the WiFi at your home. A static IP is not needed. You just need to configure your router...