John Thompson
Well-Known Member
I have been working on a project staking a bunch of points. I have the LS set to record A1 and A2 screenshots, and Auto Accept is enabled. From the pdf file, it appears that after the point is surveyed and auto accepted, the target is incremented, then the A2 screenshot is taken. This results in the A2 screenshot being taken while the LS is still on the previous point. Rather than showing the final deltas between design and surveyed coordinates, the A2 screenshot shows the distance to the next point.
Also, would it be possible to add maximum deltas (surveyed-design) to the Auto Accept Settings screen? Auto Accept saves a keystroke at each point, and it allows the screenshot (if it were timed properly) to show the final surveyed coordinates and roll/pitch/heading before I move the LS off the stake, but I don't get to see the final surveyed coordinates to see if I set the stake close enough.
Also, would it be possible to add maximum deltas (surveyed-design) to the Auto Accept Settings screen? Auto Accept saves a keystroke at each point, and it allows the screenshot (if it were timed properly) to show the final surveyed coordinates and roll/pitch/heading before I move the LS off the stake, but I don't get to see the final surveyed coordinates to see if I set the stake close enough.
