LS+ stakeout screen lockup

G

Greg Flowe

Active Member
I have had this issue happen a few times over the past couple of months. While staking out points and hitting start to verify my stakeout location, then hitting pause to read the cut to write on the stake. After a minute or 2 holding that screen, neither accepting or declining the point staked out as a stored shot, it seems to timeout on its own and excepts the point I shot. After that happens I am unable to stakeoout anymore points because the start button is greyed out. I can change to the collect screen and it works fine, but the stakeout screen remains locked up. Any thoughts on why this may happen? I m running J-Field Pre-Release 4.0.0.1219
 
G

Greg Flowe

Active Member
Adam, I did what you suggested and moved back to Release .1216 and gave it a test. I was able to make it lockup the stake out screen. Staking out a point. Stake out a point and located the point. Put the stake in, then set LS+ on top of the stake and hit start and ran it until I got enough information to verify the cut and hit stop. I wrote the cut on the stake and then stuck the LS+ in the ground to answer a phone call. While talking I here it accept the shot on its own. After I got off the phone I tap the screen to wake it back up and the start button is greyed out. No more staking out. You can go to the collect screen and it will work, switch back to stakeout screen, but still locked up. I realize a solution would be to just accept or decline the point and I probably would not have that problem, but I believe there must be some sort of glitch happening after a timeout on that screen and should not be happening. Could be something the team could look at. This has happened on multiple projects, not just one.
 
You must log in or register to reply here.
Top