T1M TCP Corrections with JetPack

Ryan

Member
I'm using the settings in the attached configuration doc to connect my T1m to the Jetpack. I'm getting the association error in Netview. Are the setting in this document correct? Any tips to get it to work? Thanks
 

Attachments

  • Javad TCP Base & Jetpack Configuration.pdf
    595.3 KB · Views: 820

Adam

Well-Known Member
5PLS
Ryan, this can be done in Base/Rover setup now. Netview isn't needed. On the jetpack you will need to go to the administrative page and set the DMZ address. Everything else is done in base/rover. In base/rover tap the communications box then tcp configuration and wifi. Enter your info there then send to base. It should connect the jetpack and base. Then go back in and make sure it says associated and no error.
 
Top