Bruce Dawson
Active Member
Hi everyone,
So I have a project that had some bad GPS areas (lots of deep, dark conifers which just seem to block ALL my signal) so I decided to drag out and dust off my total station. Took about 10 shots and incorporated them into my CAD drawing. Then I did not return to the site for about a week and forgot to allow for those ten point numbers. Today I have duplicated them in the LS and want to renumber them. I don't seem to be able to find anywhere to do that. Do I just have to do it manually?
Bruce
So I have a project that had some bad GPS areas (lots of deep, dark conifers which just seem to block ALL my signal) so I decided to drag out and dust off my total station. Took about 10 shots and incorporated them into my CAD drawing. Then I did not return to the site for about a week and forgot to allow for those ten point numbers. Today I have duplicated them in the LS and want to renumber them. I don't seem to be able to find anywhere to do that. Do I just have to do it manually?
Bruce