Hello again Matt. Thanks for the tip on hiding base and staked points, I will start doing that immediately. And yes, we are using RTCM 3.0 Min. I just returned from a site near our office and set up and checked into a known point (photo attached). Everything appears fine, so I'm assuming it's a...
HI Matt. I routinely delete "base points" prior to exporting and downloading to the office. The issue has occurred several times across several days on this ongoing project. As a routine, after staking my base point, I check in to another known point to verify we are ready to collect data or...
Hi Matt. I'm positive the base height was 4.99' This is the only project where this has occurred, but it has happened several times within this project since the recent update. Prior to the update this issue did not occur. As a habit, I point stake my base point (and that's the confusing part...
Hello. I have a Triumph LS/Triumph 2/HPT401BT. Prior to this last update, I've never encountered these issues checking into known points.. The horizontal is good, but the vertical is incorrect by a constant elevation. When I set up the RTK base unit, I always point stake to occupied base point...
Hello to everyone and thanks to the admins for approving this forum membership.
I'm a Senior Crew Chief/CAD tech for a County in Florida and we've recently purchased the Triumph LS, Triumph 2 base with HPT401BT radio. We also have a Topcon Hiper II base/rover unit that appears to be...